Rusty frame

Hi all,

Just picked up a Paconi roadie for my wife- the seller told me there was no rust. After picking it up and viewing in light of day, there is! Some small spots coming through the paint, on the chrome and where the paint has been chipped off.

What is everyone’s recommendation regarding getting the frame repaired/repainted -

Should I sand back to bare metal where the rust is and take it to a painter, or

take it to a painter (Paconi?) and let them deal with it?

Give up?

Thanks all - any advice would be appreciated.

Also, the Alumin. seat post has corroded onto the frame. Any tips on how to remove? WD40 hasn’t worked.





Well, regarding the rust on the chrome, that’s an easy fix. What you can do, is grab some kitchen alluminium foil, some hot, soapy water, and just rub the rust away. Because the al foil is softer than the chrome, you won’t have to worry about it taking the chrome off. I did this with my chrome forks and they came up a treat. =) good luck.

the rust doesn’t look too bad. you should see the paconi road frame which is my daily ride! rust everywhere… just surface rust, but don’t look too pretty.

i was considering getting it repainted at paconi. called them up, and found they were pretty useless to deal with. i’m now thinking i’m just going to go the cheap and nasty powdercoat route, and then perhaps apply some decals.

If your serious about getting all the rust get it acid dipped so you can see where you need to sand the rest off. There are some products around that claim to be rust converters also. They tend to work alright but you really have to take off most of the rust with a wire brush then apply liberally.

Or maybe find a place that will sand blast the frame

+1 for alu foil on chrome… works soooo well

Use Al foil and coca cola. it seriously works i got the extremely rusted bars of the missus bike back up to a full chromy good shine. Plus myth busters says so, though I’ve also heard of sprite and steel wool

cut the top of the seat post off. cut a slit down the middle and hammer it flat. get a shifter and turn the seat post round and round to loosen a bit. find its loosest spot and get vice grips. grab flat section of seat post and wiggle it out. did one 2 days ago like this took me all of 15mins and was easy as…

Complete 600 group, nice score. I’ve almost finished a build with the same group. Loving the gears for something different. If your converting it and taking off most of the parts let me know, probably be interested in getting some of that stuff off you.

Please dont "CONVERT’ it… its a road frame. not a track frame

Is this the Paconi that was on ebay a few days ago? If so, that’s a lovely looking bike, shame about the rust though (what a dodgy seller claiming there was no rust!). I bid on it but looks like you beat me :stuck_out_tongue:

I would love to see what it looks like after you’ve got it up and running. Are you planing on keeping it as a road bike or converting it?

Hey guys - thanks for the replies. I was sorely disappointed when I finally saw the quality of the frame after the person who sold it to me told me it was in perfect condition. When I cam to pick up she wouldn’t let me have a look in the light.

Should have known.

I am considering selling it - or if highly advised, getting it stripped, painted and re-stickered. Just have to get the seatpost out. Will give ammonia a try tonight.

I didn’t buy it for a conversion - was/is for my wife as a commuter. Is Shimano 600 Groupset decent?

Thanks again all - keep the advice coming. :slight_smile:

Adam.

600 is nice group, old Ultegra